XT32 / Crossover (new mic results)

Hi, Ok... So I received my brand new microphone (thank you Chris) and things seem to be much better. Highs have been reduced and the overall sound is not as bright as it was previously. I have one question though, when I re-ran auydssey on this occasion, it recognised all my speakers as small (except my fronts) which is bizarre as previously they were all recognised as large (which is what id expect as every single speaker is identical to the other and all are floor standing large speakers)? That aside, the x-over points were set to 40 (fronts) 60 (wides and rears) and 90 (centre) and I was wondering.... As all these speakers are identical in very way, should I raise the x-over for all them to 90 or should I raise them to 80'and leave the centre on 90? Or should I raise the fronts from 40 to 60 to match wides and surrounds, and leave the centre on 90? Is there any reason to use a x-over of 80 (while using xt32) or would I be better using a x-over of 60 which is still higher than where the speakers were defaulted to by the amp? Other than that, the new sound has been improved by replacing the mic (I really appreciate that level of support, it's very endearing) and I would like to say thanks for everything, thanks to your advice and support and the replacement mic, I am once again loving my new 7.1 XT32 setup.
Have more questions? Submit a request

33 Comments

  • 0
    Avatar
    pepar

    ... but I will try it and listen for differences the next time I'm in the theater.

    Jeff

  • 0
    Avatar
    Audyssey Labs

    Yes, hairs.  At least we still have them!

  • 0
    Avatar
    pepar

    Well, one of us does.

Article is closed for comments.